SmartUs-1M, Rev-C firmware update from 3.03 to 3.05
---------------------------------------------------------

!!! Important !!! 
This update prevent potential problem of FPGA flash memory "self erasing".
Recommended to update firmware to 3.05 version.


Programing process:

1) Connect power supply to beamformer;
2) Connect USB cable to computer;
3) Be sure that Windows recognize beamformer and "Ultrasound Scanner Monitor" is green;
4) Run firmware upgrade utility;
5) Click "Start Update" button;
6) Wait until programming process will be finished (about few minutes);
7) After programming is finished:

	a) disconnect and connect again USB cable from computer or
	b) turn computer OFF (!!! must be completely turned OFF !!!) and turn it ON again.


!!! Important !!!
Do not interrupt programming process - system will be damaged;
Be sure that PC/notebook will not go to sleep mode during programming process - system will be damaged.
This utility doing update of "SmartUs-1M, Rev-C, FW: 3.03" only.



(c) 2017 TELEMED - ultrasound medical systems
Internet: http://www.pcultrasound.com, http://www.telemed.lt
Information e-mail: info@telemed.lt
TechSupport e-mail: support@telemed.lt