LogicScan 128, rev.B firmware update from 1.00 to 1.01
---------------------------------------------------------

!!! Important !!! Update firmware only if sometimes your computer not recognize connected LogicScan 128, Rev.B beamformer. This issue was fixed in this 1.01 firmware version.

Programing process:

1) Turn power ON on beamformer;
2) Connect USB cable to computer;
3) Be sure that Windows recognize beamformer and "Ultrasound Scanner Monitor" is green;
4) Run firmware upgrade utility
5) Click "Update firmware" button;
6) Wait until programming process will be finished (about 30 sec);
7) After programming is finished:

	a) disconnect and connect again USB cable from computer or
	b) turn computer OFF (!!! must be completely turned OFF !!!) and turn it ON again.



!!! Important !!! Windows Vista users must turn OFF UAC (User Account Control) before firmware programming.


Note:

LS128_5b_0102 Firmware Upgrade - 5 bit ID probe support
LS128_6b_0103 Firmware Upgrade - 6 bit ID probe support



(c) 2015 TELEMED - ultrasound medical systems
Internet: http://www.telemed.lt
Information e-mail: info@telemed.lt
TechSupport e-mail: support@telemed.lt